I just purchased an iPhone (w/ V1.1.1 SW) and I have a Parrot CK3000 Evolution car-kit (w/ V5.10c firmware)It will discover the kit fine and pair, but when I reenter the car later it seems very unreliable in repairing. One time it did pair several minutes after entering the car, and the other time it did not seem to connect - but did when I unpaired and repaired (reentered PIN).Anyone finding any tricks to make this work better? I just got off the phone with Apple support to no avail (could not find any info on it). I've also sent a note to Parrot support.

• Parrot Ck3000 Volume

Apple Footer.This site contains user submitted content, comments and opinions and is for informational purposes only. Apple may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Apple can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Apple disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the.

Parrot Ck3000 Volume

If your Parrot 3000 Evolution has been installed by a professional technician.Should this not be the case, follow the steps to correctly install your Parrot Evolution!Parrot Evolution comprises an electronic box, a microphone, a remote control with 2 buttons, and two ISO connection cable bundles for car radios.Electronic box: Do not fit near to heating or air conditioning units. Protect your electronic box from direct sunlight. Avoid enclosing the electronic box with metal panels, which will have an impact on the quality of the Bluetooth link.Microphone: It should point towards the driver and preferably be installed between the sun visor and the inside rear-view mirror.Keypad: We recommend that you install the keypad in a location that can be easily accessed, preferably on a flat surfaced that has been cleaned beforehand. Link the keypad to the designated connector on the mute cable.

Check that the red and green indicator lights turn on and off depending on the position of the ignition switch.Connecting the mute cable and power cable: The mute cable is fitted with black ISO connectors. The power cable is fitted with gray ISO connectors.Car radio with ISO sockets: Disconnect the audio and power cable bundles from the car radio. Gnostice oneview v1.0 crack. Then connect the female connectors of the mute cable and the power cable to the car radio.Next, connect the audio and power cable bundles from the vehicle to the male connectors.For car radios without ISO sockets: You can use an adapter cable bundle specific to the vehicle (not provided). If you do not have an adapter, install the wires one by one if the vehicle does not have an ISO connection configuration.If the car radio has a 'Mute' in, connect the yellow wire of the mute cable.